The installation and construction technology of FRP wind pipe is the key point of this project. Inorganic glass fiber reinforced plastic wind pipe has been widely used in recent years. With the improvement of manufacturing technology and the application in large-scale engineering, construction workers have been able to master this mature construction technology. In this project, the glass glass steel wind pipe has a large amount of application and high installation requirements, so it is the key and difficult point in the construction of the ventilation and air conditioning system in this project.

　　通風機（含排煙機）的安裝

　　The installation of a ventilator (including a smoke exhauster)

　　1）整體安裝的風機，搬運和吊裝的繩索不得捆縛在轉子和機殼或軸承蓋的吊環上。

　　1) whole fan installed, carrying and lifting rope shall be bound in the rotor and the shell rings or the bearing cover.

　　2）通風機的進風管、出風管等裝置應有單獨的支撐，并與基礎或其它建筑物連接牢固；風管與風機連接時，不得強迫對口，機組不應承受其它機件的重量。通風機傳動裝置的外露部位以及直通大氣的進、出口，必須裝設防護罩（網）或采取其它措施。

　　2) the inlet and outlet pipes of fans should have independent support and are firmly connected with foundations or other buildings. When air pipes are connected with fans, they must not be forced to match counterparts, and the crew should not be able to bear the weight of other parts. The outgoing parts of the ventilator transmission and the inlet and outlet of the direct air must be equipped with a protective shield (net) or other safety measures.

　　3）落地安裝的離心風機：其基礎應平整，通過調整減振器的位置，使各減振器受力及變形尺寸一致。

　　3) a centrifugal fan installed on the ground: its foundation should be flat, and by adjusting the position of the damper, the size of the force and deformation of each damper is consistent.

　　4）懸吊式軸流類風機安裝：風機加設鋼板連接板及型鋼挑梁，使各個減振器受力及變形尺寸一致。

　　4) installation of suspension type axial flow fan: the fan is equipped with steel plate connecting plate and type steel pick beam, so that the size of each damper is in accordance with the force and deformation size.